Physical Connections
Begin by connecting your video source to the encoder's HDMI input port. Ensure the source is powered on and outputting a signal. Next, connect the encoder to your network using an Ethernet cable. Plug the other end into a switch or router within your network. Finally, connect the encoder's power adapter and turn the device on.
Network Configuration
Access the encoder's web-based management interface, typically by entering its IP address into a web browser on a computer connected to the same network. You will need to configure network settings like IP address, subnet mask, and gateway if not using DHCP. Set up the streaming output parameters, including the streaming protocol (e.g., RTMP, RTSP), server address, and stream key.
Testing and Optimization
Once configured, test the stream by accessing it from a compatible IPTV player or software on another device on your network. Verify video and audio quality. Adjust encoding settings such as resolution, bitrate, and frame rate as needed to balance quality with network bandwidth. Monitor the stream for stability and latency.
Key Benefits
- Connects HDMI sources to your IP network.
- Provides web-based configuration interface.
- Supports various streaming protocols.
- Allows bitrate and resolution adjustments.
- Enables live video distribution.
Frequently Asked Questions
What IP address should I use?
Use the encoder's default IP address or the one assigned by your DHCP server. Consult the manual.
How do I find the encoder's interface?
Open a web browser and type the encoder's IP address into the address bar.
What is a stream key?
A stream key is a unique identifier used by streaming servers to identify your specific stream.
Do I need a static IP for the encoder?
A static IP is recommended for consistent access, but DHCP can work for initial setup.